.

Safety Issues :
• What is the safety factor of a Stagemaker hoist ?

• May I use a Stagemaker for loads over people ?

• Can I use different hoists to support one load ?

• What is the impact to the supporting structure in case of an Emergency stop ?

Operational Issues :
• Can I use a Stagemaker hoist outdoor ?

• The chain is rusty what should I do ?

• What should I do to keep my chain in good condition ?

• What should I do to keep my hoist in good and safe condition ?

• Are there any instructions to follow when running the chain through the hoist ?

• What should I do to prevent damage to the chain guide ?

• What should I do when the chain got stuck in the chain guide ?

• Where should I go for spare parts ?

Voltage drop and cable length :
• What is the maximum permissible voltage drop on a Stagemaker hoist ?

• What is the maximum cable length between hoist and controller ?

Loads, overloading and overload protection :
• What is the maximum permissible loading of my Stagemaker hoist ?
• Is a Stagemaker hoist protected against overloading ?
• What happens in case of over loading ?
• Can I use the clutch setting as a loading reference ?
• What is the correct setting of the overload clutch ?
• How can I adjust the overload clutch ?
• When should the clutch be replaced ?
Up & Down Limits :
• Has a Stagemaker hoist limit switches ?

• Can I use limit switches for positioning ?

Modifications :
• What should I do to increase the capacity of my hoists ?

• What should I do to modify my hoists from 2 fall in to 1 fall ?

• Is there a double brake retrofit option available ?

Controller R8CPU-VS :
• My system doesn’t start up:

• My system starts up, but trips off now and then:

• My system doesn’t start up, there is power, phases are in good order:

• My system doesn’t start up, there is power, phases are in good order, blind plugs an cables are fitted and 24Vdc circuit breaker is switched on:

• Hoists are not moving after system start up, green LED is on

• Hoists are moving only in slow speed after system start up, green LED is on

• Hoists is not moving, yellow LED channel indicator remains off

• Hoists is not moving, yellow LED channel indicator flashes

Software issues :
• What is the user ID and password ?

• There is no communication and system shows IP address error messages

• Position counter or position table has RED background

• Hoist bar graphs are not shown on Movement page

• GO button doesn’t appear on the Movement page

• Hoist position counter doesn't move